Eltakoradio-controlled current relay, FSR61-230 V wireless actuator

• Switches, power supplies and electronic power meters..
• For building installations and controlling technologies..

1 NO contact potential-free 10 A/250 V AC, incandescent lamps 2000 watts, release delay with early warning switch-off and continuous light connectible push-button. Encrypted radio, bidirectional radio and connectible repeater function. Stand-by loss only 0.8 watts. For built-in installation. 45 mm long, 55 mm wide, 33 mm deep. Supply and control voltage locally 230 V. If the supply voltage fails, the sw state remains. With recurring supply voltage is switched off in a defined manner. After installation, wait for the automatic short synchronization before putting the switched load on the grid. In addition to the radio control input via an internal antenna, this wireless actuator can also be locally controlled with a conventional control button that may have been ed in front of it. A glow lamp current is not allowed. From the production week 11/14 encrypted sensors can be programmed. It is possible to switch on bidirectional radio and/or a repeater function. Each status change as well as received central control telegram is then confirmed with a radio telegram. This radio telegram can be programmed in to other actuators the GFVS software and universal displays. Scene control: with one of the four control signals of a button with a double rocker programmed as a scene button, several FSR61 can be switched on or off for a scene. In the LRN position, up to 35 wireless push-buttons are assigned to the upper one, of which one or more central control push-buttons. Additionally, wireless window/door contacts with the open or closed function with the window open, wireless outdoor brightness sensors FAH and wireless motion detector FBH. Thereafter, the desired function of this surge sw relay is chosen: ER = sw relay. ESV = impulse switch. If necessary, with release delay, then + push-button continuous light = ESV with push-button continuous light, + switch-off warning = ESV with switch-off early warning, + push-button continuous light and switch-off early warning = ESV with push-button continuous light and switch-off early warning. When the button light is switched on, buttons can be set to steady light for longer than 1 second, which is automatically switched off after 2 hours or can be switched off by pressing. When the switch-off warning is switched on, the lighting flickers about 30 seconds before the time starts and a total of 3 times at shorter intervals. If the switch-off warning and the push-button continuous light are switched on, the switch-off warning will be activated after the permanent light is switched off automatically. With the lower rotary switch, the release delay can be set from 2 to 120 minutes in the ESV function. In ES position: infinitely normal impulse switch function without release delay, without push-button continuous light and without switch-off early warning. In ER position: sw relay of the other rotary switch fulfils a safety and power saving function in the settings except infinity: if the switch-off command is not recognized, e.g. due to a jammed or too hastily actuated button, the relay switches off automatically after the time between 2 and 120 seconds has elapsed. If the FTK has been programmed in, this time function is switched off. Twilight switch with programmed in wireless outdoor brightness sensor FAH and motion detection with trained radio motion detector FBH according to the operating instructions (English language not guaranteed.) The LED accompanies operating instructions (English language not guaranteed.) and shows radio control commands during operation by briefly flashing.