1M Black Silicone Shower Threshold Water Barrier,Wet Room Floor Barrier,Shower Tray Sealing Strip,Bathroom Bath Edging Sealing Strip Trim,Caulk Strip,Water Retaining Dam for Sink,Bathtub

Cautions: In order to achieve stable and lasting effect , please pay attention to the follow question


Purchase a size that is 5cm-10cm longer than the required length !

Clean the ground and dry it before installation!

This floor seal suit for kinds of Smooth flat floor, such as smooth marble floor, coating floor and other smooth surface. can not use for Severe sags and crests floor, big gap floor and Mosaic glass floor.

Not peeling all of sticker one-time: Mark the position and measure suitable length before peeling sticker, peeling sticker little by little one side and then press the peeled position to the surface as the same time, then peeling left little by little. Not peeling all of sticker for one-time and pull up the water retaining strip if found its not install well.

use with silicone sealant: Fill the gap between the walls with the two ends of the water barrier and all around of bottom by silicone sealant to achieve a completely hermetic effect, remove the excess glue to make the contact smooth.

After the installation is completed, it needs to be kept dry for 24 hours, and it needs to be postponed for 1-2 days in autumn and winter.





Appilcation:
Sink Countertop,Shower Cubicle,Shower Door Bottom,Bathtub,Shower Floor


Installation method:
Measure:Measure the length and width of the countertop, In the corner, we recommend you cut it to 45 degree, and then connect two part to ensure its firmness.

Tear off the adhesive: in this process avoiding dust on the adhesive strip and affecting its adhesion.

Paste: apply the water dam seal gently and slowly, keeping it horizontal or vertical, pressing gently with your fingers.

Glue:The most important and necessary step is to fill the bottom edge of the water retention strip with caulk to ensure a long-lasting and strong adhesion.

• 【How To Install】:First clean and dry the surface, measure and cut the shower water stopper to your length, peel off the red adhesive back strip, stick to the Smooth Surface.Notice:For Long Use, It Is Must To Use Silicone Sealant(Glue) To Fill The Edges Of The Water Barrier And Dry For 24 Hours Until The Sealants Is Solidified(The Package Do Not Contain Silicone Sealant)!!!if you have any question,please feel free to contact us!.
• 【High Quality Silicone Material】:The water dam is made of food grade silicon, which is corrosion resistant, high temperature resistant, wear resistant. The bath edging strip is soft and does not hurt your feet..
• 【Wide Application】: It can be used on shower floors,shower trays,kitchen sinks,under bathroom doors,bathtub edgings,around washing machines or toilets to form a water barrier, effectively stopping the flow of water and achieving wet and dry separation, keep your home away from damp!.
• 【Size】: The size of the silicone water barrier is 15mm H x 25mm W ,two installation methods are provided, you can choose to install it horizontally or vertically according to the size of the gap (as shown in the picture);3 meters in length ,you can cut to the length you need!.
• 【Attention】: 1,The silicone floor seal is only 15mm in height ,which cannot meet the requirements of barrier-free showers and large water holding areas. 2,The bath splash guard can only be fixed in a straight line, not bent.At the corners we recommend cutting to 45 degrees, splicing 90 degrees to paste..